Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Last revision Both sides next revision | ||
|
picker:tilt_pair_picking [2017/06/12 15:53] kbertra2 |
picker:tilt_pair_picking [2017/06/12 19:40] kbertra2 |
||
|---|---|---|---|
| Line 28: | Line 28: | ||
| - From this point, work with //tilted data// until otherwise noted. You will deal with the tilted and untilted data separately. Once the data is appended, it needs to be filtered. Find the [[eyes:logics:Filtering|]] logic and connect it with the [[eyes:logics:Append|]] logic. Click on the [[eyes:logics:Filtering|]] logic and apply the following settings: Processor = Gauss bandpass, Upper frequency = 0.6, Lower frequency = 0.04, Show filter function = unchecked, Transmission = 0. Click the "Play" icon to run the logic. | - From this point, work with //tilted data// until otherwise noted. You will deal with the tilted and untilted data separately. Once the data is appended, it needs to be filtered. Find the [[eyes:logics:Filtering|]] logic and connect it with the [[eyes:logics:Append|]] logic. Click on the [[eyes:logics:Filtering|]] logic and apply the following settings: Processor = Gauss bandpass, Upper frequency = 0.6, Lower frequency = 0.04, Show filter function = unchecked, Transmission = 0. Click the "Play" icon to run the logic. | ||
| - Next select the [[eyes:logics:Normalization|]] logic and connect it to the [[eyes:logics:Filtering|]] logic of the previous step. Click on the [[eyes:logics:Normalization|]] logic and apply the following settings: Processor = Normalize against background, Invert = (select yes if micrographs were acquired in negative stain). | - Next select the [[eyes:logics:Normalization|]] logic and connect it to the [[eyes:logics:Filtering|]] logic of the previous step. Click on the [[eyes:logics:Normalization|]] logic and apply the following settings: Processor = Normalize against background, Invert = (select yes if micrographs were acquired in negative stain). | ||
| - | - Find the [[eyes:logics:Rct2|]] (random conical tilt) logic and connect it to the output of [[eyes:logics:Normalization|]] to "io:tilted" input of the [[eyes:logics:Rct2|]] logic. Before running the [[eyes:logics:Rct2|]] logic, click on it and adjust the settings as shown below (note: pixel size varies): | + | - Find the [[eyes:logics:rct|]] (random conical tilt) logic and connect the output of [[eyes:logics:Normalization|]] to "io:tilted" input of the [[eyes:logics:rct|]] logic. Before running the [[eyes:logics:rct|]] logic, click on it and adjust the settings as shown below (note: pixel size varies): |
| {{ :picker:selection_008.png |}} At this point, your logics should be set up in the following way: {{ :picker:selection_009.png |}} | {{ :picker:selection_008.png |}} At this point, your logics should be set up in the following way: {{ :picker:selection_009.png |}} | ||
| Note that the input labeled "io:untilted" has not been connected. Your //untilted// data must now be processed. | Note that the input labeled "io:untilted" has not been connected. Your //untilted// data must now be processed. | ||