Differences

This shows you the differences between two versions of the page.

--- eyes:logics:adjustpixelvalueoutlier [2017/06/12 17:15]
gbunzel [Modes/Processes]
+++ eyes:logics:adjustpixelvalueoutlier [2017/06/12 18:32] (current)
jschlie1
@@ Line 5: / Line 5: @@
 This module can be used to remove hot pixels as determined by the set criteria. The hot pixels are then replaced by pixels within the normal range with specified type.
-===== Example ====
+===== Parameters and I/O =====
-Here, a very specific example should be given/described. In the future, this can be supported by screenshots etc.. For the moment, give an example easy enough for the user to understand, but specific enough to elaborate why a given parameter is a good set for this very situation.
-===== Modes/Processes =====
-==== thisIsTheNameOfMode1 ====
-Here, a short introduction for the given mode should be placed. Again, state WHAT and WHY this mode us useful in not more than 2 sentences.
 |< 100% 30% >|
 ^ Parameters                 ^ Description     ^
@@ Line 22: / Line 16: @@
 | -> Custom value   | Replace outliers with the to the mean value of the complete image |
 | -> Image mean   | Replace outliers with a specified custom value |
+| Deviations from mean [in sdevs]       | Choose the multiples of standard deviations from mean that are considered to be an outlier. |
 |< 100% 30% >|
@@ Line 33: / Line 28: @@
 |< 100% 30% >|
 ^ New/Changed Header Values ^ Description ^
-No header values are being changed.
+| |No header values are being added or changed. |
 ===== Concept =====
 A discussion of different CCD characteristics including hot pixels can be found [[http://scripts.iucr.org/cgi-bin/paper?S0907444909031205|here]].